Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bigbud

Pages: [1]
1
Drivetrain / air locker
« on: May 08, 2011, 12:02:39 am »
has any one ever put an air locker in their differrential in a bombadier,and did it work in the cold weather?

2
Drivetrain / factory gear ratio
« on: February 18, 2011, 07:31:03 pm »
any one know what was the factory gear ratio and what rear end was used new .year is 74-318 auto (235612)(AA74)6199V

3
Drivetrain / ring +pinion
« on: February 18, 2011, 07:26:42 pm »
will the ring +pinion from a dana 60 semi float fit into a dana 60 full float?

4
Drivetrain / what gear ratio to go with?
« on: February 17, 2011, 10:48:28 pm »
got a dana 60 rear end in wide guage bom#603319-1  with 4 11s its a semi float,got another dana60 but it has 3 56s and its a full float.what should i expect with the 356s better gas milage or worse or should i stay with 411s?

5
For Sale - Vehicles / 1974 wide guage for sale
« on: December 19, 2010, 02:03:59 pm »
1974 wide guage AA74-6199V-E235612  new 4 ply rubber tracks,new glass,new bearings and races through out ,new front swing arms and new skis,new ignition,primed and painted this summer,rack on top,power steering pump rebuilt,complete new wiring front to back  318 industrial engine,2 barrel carb,727 torqueflite tranny,dana 60 diff,2 new bogies,new chains ,new spindle bearings,new track tensioner bearings , good machine for winter roads or winter fishing,two cargo doors  no pics yet,dont know how to post pictures 25000 and its yours

6
Wanted / wanted;318 industrial
« on: December 11, 2010, 09:32:27 pm »
i am looking for a 318 industrial engine,also looking for a couple of bombardier rims .please let me know what you have my email is hotsaw4@hotmail.com thank you

7
General Electrical / alternator wires
« on: November 19, 2010, 12:00:05 am »
rebuilding a 74 wide,318,auto.where do the alternator wires go to?i am putting a different distributor shaft in,this one is dodge bottom chevy cap,coil,and internals.machine needs complete wiring .i want to have a very simple wiring harness,my idea is run a wire from power source to keyed switch then to ignition.i want to use push button starter switch,so if i wire directly to starter solenoid do i still need a starter relay? and lastly the alternator wires,i think i have to go to a regulator or?  or is it possible to hook up a one wire delco alternator?

Pages: [1]