Author Topic: Engine Cubby Cooling  (Read 6090 times)

Offline Skenman

  • Newbie
  • *
  • Posts: 28
    • View Profile
Engine Cubby Cooling
« on: February 24, 2007, 08:27:36 pm »
I have installed a 12v radiator push/pull fan on the drivers
engine door. I run it off a tobble switch, to take extra air cooling on hot days
+ engine / cabin fumes away. It is working very well.

My after thought was maybe installing a 4" Marine engine blower
to look after same,, with much less amp draw,, 

Skenman
62 wide

Offline Swamp Dawg

  • Sr. Member
  • ****
  • Posts: 272
    • View Profile
Re: Engine Cubby Cooling
« Reply #1 on: February 24, 2007, 11:09:13 pm »
Good Idea!

Offline grfishmaker

  • Full Member
  • ***
  • Posts: 213
    • View Profile
Re: Engine Cubby Cooling
« Reply #2 on: March 29, 2008, 05:04:23 pm »
« Last Edit: April 23, 2008, 07:31:25 am by grfishmaker »

Offline Swamp Dawg

  • Sr. Member
  • ****
  • Posts: 272
    • View Profile
Re: Engine Cubby Cooling
« Reply #3 on: March 29, 2008, 05:52:16 pm »
What kind of fan is that?  We are looking at getting a Flex-a-lite with a temperature control system, so it turns on automatically at certain engine temp.

Offline Skenman

  • Newbie
  • *
  • Posts: 28
    • View Profile
Re: Engine Cubby Cooling
« Reply #4 on: March 29, 2008, 06:15:08 pm »
Boyz,
Its a current model vehicle fan, not sure, got off shelf in salvage.
Bingo, lookin back at my original post, saying to use a marine blower
I had forgot.. but
I really want someone to try this,,  thinkin that it will work better and
save battery power, specially if you only run 1 battery.

I would tie the suction hose to the tub cellar.,  mount the fan coupling
where the old battery location was, and that would be it.

Quieter, less amps. and could run at all times,, enhancing the cold air draw
through the rad and also removal of extra hidden carbon monoxide in the engine tub.
 

Offline the old trucker

  • Hero Member
  • *****
  • Posts: 1461
    • View Profile
Re: Engine Cubby Cooling
« Reply #5 on: March 30, 2008, 08:25:28 am »
Swamp Dawg your idea sounds good, but do you think it would be a good thought to wire in a manual override switch. Just in case you need to use it before the sensor cuts it in, or worst case fails!! Do you get any fumes inside when idling for a few minutes? We've always had them (manual override switch)in trucks. Wondering what your thoughts are? Waiting for new posts. Keep up the great work!!!
« Last Edit: March 31, 2008, 06:34:39 pm by the old trucker »
after covering a few acres of prime real estate.

Offline Swamp Dawg

  • Sr. Member
  • ****
  • Posts: 272
    • View Profile
Re: Engine Cubby Cooling
« Reply #6 on: March 31, 2008, 10:12:20 pm »
We've managed to seal off the inside quite well.  No fumes at all coming in.