Author Topic: Pictures of Skenman's Bombardier  (Read 6098 times)


Offline Averyman

  • Jr. Member
  • **
  • Posts: 86
    • View Profile
Re: Pictures of Skenman's Bombardier
« Reply #1 on: February 09, 2007, 09:01:09 pm »
What on earth is that "thing" strapped to the front of your machine???

Offline Skenman

  • Newbie
  • *
  • Posts: 28
    • View Profile
Re: Pictures of Skenman's Bombardier
« Reply #2 on: February 09, 2007, 10:48:22 pm »
that right there is a protective case for an 8" Jiffy ice auger,

 

Offline Swamp Dawg

  • Sr. Member
  • ****
  • Posts: 272
    • View Profile
Re: Pictures of Skenman's Bombardier
« Reply #3 on: February 10, 2007, 10:21:43 am »
Where did you get that Alum fuel tank made?

Offline Skenman

  • Newbie
  • *
  • Posts: 28
    • View Profile
Re: Pictures of Skenman's Bombardier
« Reply #4 on: February 10, 2007, 10:57:34 am »
I took some measurements and gave them to an outfit to custom make.
in Lloydminster, Saskatchewan. It was about $500 , all mounts are double / triple
re-paded where the bolts go, also inside baffled for no slosh. I ran ss316 tubing to elec. fuel pump, than off to carb.and drilled installed napa fuel sender.
Pros:]
no rust, filters plugging, no elevated / cooling temperatures on the fuel= deicer & vapour locking. Better cooling for engine compartment, can remove cabin fuel tanks and re-locate batterys. no fuel spill in engine comparment. Freed room in engine
compartment could be used to mount a small tool box etc.
Cons:
cannot close snow door infront of rad. although the only time this is a
con , is when u get 1 foot of snow filling in the opening. other than that the rad keeps snow melted off even when going through powder. A person could make
a snap on cover to aleviate that problem if you want.

*****


 


Offline Swamp Dawg

  • Sr. Member
  • ****
  • Posts: 272
    • View Profile
Re: Pictures of Skenman's Bombardier
« Reply #5 on: February 24, 2007, 04:29:39 pm »
Uploaded a couple more pictures.  I added them to the top ^^^