General Forums > Wooden Bombardiers

OT'S 47-51 ??? Rebuild ??

<< < (17/42) > >>

the old trucker:
[. Also took a pic of the way the vacuum hose is pointing on the distributor. http://i966.photobucket.com/albums/ae141/orinleecarlson/009.jpg

 This is Orins oil filter & dist. I plan to try & do the same with mine. If I have to move the oil filter, I'll see if I can find something around localy.
    Would oil run through a fuel filter mounting bracket ?? I had a remote (primary) fuel filter own my trucks. Maybe an oil filter may fit right in place. Any thoughts ??

                                                                             OT. 

bluetoque:
OT when I installed my 300 I took a hole saw and made a slightly larger hole in line with the filter.Filter is just flush with the tub...works like a dam to remove and replace. Your going to need the odd extra hole to disperse the heat that engine will generate when you put her to work!

the old trucker:

  Swamp Dawg what are you using for a muffler in your bomber ?? I looking to have a deep mellow sound to her when under load. Guess I'm old school.
  I love the sound of Cam's bomber. In your video, go to min.7;40 of it & listen to that beautiful sound.
 
PS;; TURN UP THE VOLUME !!!!                                                 
                                                            A Quivering OT.                                   

the old trucker:

    Would anyone have any pics of the parts that I need to put my rim onto the axle ?? I know the front three axles have a spacer on them to line the wheels with the back one. I have nothing. I wanted to see what I can get or make locally before buying. Isn't there a big washer that goes on before the inner bearing goes on ?? Then the rim, outer bearing with another big washer before the nut & cotter pin. I have a manual but it's not clear enough to see. I want to put 4 wheels on now to help carry the extra weight of the engine.
 
                                                                          OT.

oldsledz:
O.T. 

I had new ones made for mine for they were worn a bit from running the bearing too loose.  I still have them and I could get you the dimensions.  You may check with Dan also.    There is no washer,  it just slides onto the spindle and then the inner bearing.  The spacers also act as a rubbing face for the wheel seal as well.  AND------  I have traced the plywood templates but the paper is huge.  about 5' tall and about 12" round when rolled up.  I am going to Valcourt tomorrow and then to St Raymond on Sunday witht the B12.   Do you have anyone you know that will be there,  I could give the templates to them.

Oldsledz

Navigation

[0] Message Index

[#] Next page

[*] Previous page