General Forums > Wooden Bombardiers
OT'S 47-51 ??? Rebuild ??
the old trucker:
LOOKS LIKE THINGS ARE GETTING MUFFLED !!
We got the exhaust system made up today & managed to keep it in the original spot. There's about 3/4" clearance around it. Used a small 3" resonator & tied in a short piece of braided flex line. Tomorrow, we will make a "double" elbow so it will exit through the side. We used muffler clamps on the joins. We could have got more clearance if the joins were welded, but I think this will do. It's a good thing we made the access panels 2" wider than original.
Will all this work.... I hope it will. Here's a few pics of the setup.
http://i333.photobucket.com/albums/m366/theoldtrucker/PICT0423.jpg
http://i333.photobucket.com/albums/m366/theoldtrucker/PICT0425.jpg
http://i333.photobucket.com/albums/m366/theoldtrucker/PICT0426.jpg
http://i333.photobucket.com/albums/m366/theoldtrucker/PICT0422.jpg
kpm:
..looks like it should work,that braided line will allow some flex..
kpm
the old trucker:
Grfishmaker, Orin, kpm, Gror, Oldsledz, Chopperguy.... Can either one of you tell me what you used for your gas linkage from engine to pedal. Anyone got a pic of how the gas pedal linkage fits ?? I have the original linkage but I need to see how it fits in place..
Thanks, OT.
kpm:
it's just on a rod OT...all the way back then up the firewall.
kpm
kpm:
without taking up the floor it's hard to get a picture from front to back...it's just a rod with a u clevis attached on to the pedal at front.
kpm
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version